select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Cover

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Right Cover

Removal

Switch off the product and remove the power cable.

1. Unclip the Quick reference Guide Holder from the rear of the Printer.

2. Using a small flat-blade screwdriver, unclip the Front Panel Bezel from the Right Cover.

3. Remove the Front Panel Bezel from the Right Cover.

4. Remove two T-15 screws (Type G) that secure the Front Panel to the Right Cover.

5. Open the Printhead Cleaner Door.

6. Remove one T-15 screw (Type J ) that secures the Right Cover.

7. Open the Window and remove two T-15 screws (Type J) that secure the Right Cover.

8. Remove one T-15 screw (Type J ) and one T-20 screw (Type A ) that secure the Right Cover from the rear of the Printer.

9. Remove the Right Cover from the Printer.

When installing the Right Cover, make sure you leave the Printhead Cleaner Door open, otherwise you could damage the Printhead Cleaner Door Sensor.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company