select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Ink Supply Station (ISS)

Removal

Switch off the product and remove the power cable.

1. Remove the Left Cover.

2. Remove the Left Connector Cover.

3. Disconnect the Electrical Cable from the rear of the Ink Cartridge Tube Connector.

4. Disconnect the Air Tube from the Ink Supply Tubes.

5. Twist the 2 latches at the rear of the Ink Cartridge Tube Connector and release the complete assembly.

6. Disconnect the two Ink Supply Station cables from the PrintMech PCA.

7. Release the Ink Supply Station from the Chassis.

8. Remove the Ink Supply Station from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company