select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

PrintMech PCA

Removal

Switch off the product and remove the power cable.

1. Remove the Left Connector Cover.

2. Remove three T-15 screws (Type A) that secure the PSU cover.

3. Remove the PSU Cover from the Printer.

4. Disconnect ALL cables from the PrintMech PCA.

5. Remove two T-15 screws (Type B) that secure the PrintMech Cover.

6. Slide the PrintMech Cover out of the Printer.

7. Remove eight T-10 screws (Type I) that secure the PrintMech PCA.

8. Remove the PrintMech PCA from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company