select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Carriage Flex Cables

Removal

Switch off the product and remove the power cable.

1. Remove the Right Cover.

2. Press the two side of the Carriage PCA Cover and unclip from the Carriage Assembly.

3. Release the ALL the clips, securing the Carriage Flex Cables to the Carriage Assembly, by pulling upwards.

4. Disconnect the Flex Cables from the Carriage PCA.

5. Remove eight T-8 screws (Type L) that secure the Carriage Flex Cables to the Carriage Assembly.

6. Open the Carriage Cover and remove ALL the Printheads from the Carriage Assembly.

7. Remove the Carriage Flex Cable from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company