select printer | 4000 series | disassembly | disassembly instructions

» disassembly instructions

» Introduction

» Right Connector Cover

» Left Connector Cover

» Front Panel

» Service Station

» Drop Detector

» Ink Supply Tubes and Trailing Cable

» ISS to Cartridge Cables

» Cutter Assembly

» Ink Supply Station

» APS Assembly

» Most Left Spittoons

» Middle Left Spittoons

» Encoder Strip and Encoder Sensor

» Carriage PCA

» Carriage Flex Cables

» Carriage Assembly

» Belt Assembly

» Scan-Axis Motor

» Media-Axis Motor

» Interconnect PCA

» EIO to PCA Interface Card

» Gamut PCI PCA

» Memory Module

» Main PCA Formatter

» Hard Disk Drive

» Power Supply Unit

» PrintMech PCA

» Formatter Battery

» Media Deflector

» Front Platen

» Center Platen

» Cartridge Trays

» Input Roller

» Media Sensor

» Encoder Disc and Sensor

» Media Lever Sensor

» Pinchwheel Assembly

» Center Guide

» Drive Roller

» Right Rollfeed Module Assembly

» Right Spindle Lever



	» send feedback or comments

Front Panel

Removal

Switch off the product and remove the power cable.

1. Remove the Right Cover.

2. Remove the Rear Door.

3. Remove the Right Connector Cover.

4. Disconnect the Front Panel Cable from the Interconnect PCA.

5. Disconnect the Ferrite clip (located on the rear of the Electronics Module) from the front of the Printer.

6. Move the Front Panel Cable (including the ferrite) out of the Electronics Module.

7. Release the Front Panel Cable from the Right Arc.

8. Disconnect the Ferrite clip from the Right Arc.

9. Remove two T-15 screws (Type G ) that secure the Front Panel to the Printer.

10. Remove the Front Panel from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company