hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

tensioner assembly



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Right Hand Cover

			2. Remove the Left Hand Cover

			3. Remove the 5.5 mm nut from the left hand side of the Printer that attaches the Encoder Strip to the Spring Clip. TIP: The next step is performed by putting pressure on the Spring Clip as shown.

			4. Release the Encoder Strip from the retaining pin on the Spring Clip.

			5. Using a screwdriver, fully tighten the Spring Release Screw to release the tension on the Belt.

			6. From the right-hand side, lift the Tensioner Belt off the Scan-Axis Motor.

			7. Remove 1 T-15 screw (Type L) from the Tensioner Assembly.

			8. Remove the Belt Wheel on the left side.

			9. Remove the Tensioner Assembly from the left-hand side.



	Installation of Tensioner Assembly NOTE: Before installation, clean and oil the Slider Rods using the User's Slider Rods Lubrification Kit.



	WARNING: Be careful not to twist the Belt when installing the Tensioner Assembly.



	WARNING: When installing the Encoder Strip, make sure it is inserted in the Encoder Sensor on the rear of the Carriage Assembly as shown below.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company