4. Disconnect
APS Cables (P5, P4 and P3) from the ISS PCA.
5. To
remove the ISS, stand at the end of the Printer and press in the retaining
clip on the ISS.
6. While
pressing in the retaining clip (step 5), rotate the right side of
the ISS up and left.
7. Pull
out the right side of the ISS.
8. Slide
the ISS to the left and pull out the left side to remove from the
Printer.
Installation of ISS
NOTE: If the ISS is to be replaced, make sure you remove the APS
from the old ISS and, after installing the Grounding Plate, reinstall
it on the new ISS.
WARNING: When replacing
the ISS remember to insert the Grounding Plate into the slot as
shown (before reinstalling the APS).
