hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Scan-Axis Motor



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Right Rear Cover

			2. Remove the Left Hand Cover

			3. Remove the Right Hand Cover

			4. Remove the 5.5 mm nut from the left hand side of the Printer that attaches the Encoder Strip to the Spring Clip. TIP: The next step is performed by putting pressure on the Spring Clip as shown.

			5. Release the Encoder strip from the Spring Clip.

			6. Using a screwdriver, fully tighten the Spring Release Screw to release the tension on the Belt.

			7. Disconnect the Scan-Axis Motor Cable from position P23 on the Main PCA.

			8. Unclip the Scan-Axis Motor Cable from underneath the Service Station.

			9. From the right-hand side, lift the Tensioner Belt off the Scan-Axis Motor.

			10. While supporting the Scan-Axis Motor, remove 2 T-15 screws (Type B).

			11. Lower the Scan-Axis Motor and remove from the Printer.



	Installation of the Scan-Axis Motor NOTE: Before installation, clean and oil the Slider Rods using the User's Slider Rods Lubrification Kit.



	WARNING: When installing the Encoder Strip, make sure it is inserted in the Encoder Sensor on the rear of the Carriage Assembly.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company