hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Memory and BootROM DIMM's



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove 4 T-10 screws (Type P) from the DIMM Access Cover. Remove the DIMM Access Cover.

			2. To remove a DIMM, first push down the lower locking tab and then push up the upper locking tab to release the DIMM.

			3. Pull out the DIMM. Take care that it does not fall out.



	Installation of DIMM's WARNING: When installing the DIMM's make sure they are in the correct position as shown in the diagram.



	NOTE: Note the position of the BootROM and the SDRAM (memory) modules.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company