hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Drop Detector Assembly



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Right Rear Cover

			2. Remove the Right Hand Cover

			3. Remove the Service Station Assembly

			4. Disconnect the Drop Detector cable from the Service Station Cable.

			5. Release the cable from the Service Station.

			6. Remove the T-15 screw (Type F) that attaches the Drop Detector Assembly to the Service Station.

			7. Remove the Drop Detector from the Service Station.



	NOTE: Move the Drop Detector towards the front of the Service Station until the locating pin reaches the end.



			8. Lift the Foam from the Service Station.



	NOTE: The Foam may be full of ink so be careful when handling it.



	NOTE: Perform the following Service Calibration if the Service Station Assembly is replaced: -Service Station Calibration


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company