select printer | 5000/5500 series | disassembly | disassembly instructions
hp designjet 5000/5500 series printers
» disassembly instructions
  » disassembly instructions
» Top Cover
» Left Hand Cover
» Right Hand Cover
» Front Panel
» Left Rear Cover
» Right Rear Cover
» Extension Cover
» Media Lever
» Right Hand Trim
» Left Hand Trim
» Back Cover
» Ink Tubes System
» EMC Covers
» Encoder Strip
» Trailing Cable
» Tensioner Assembly
» Carriage and Belt
» Line Sensor
» Scan-Axis Motor
» Cutter Assembly
» Ink Supply Station
» Air Pressurization System
» Service Station
» Drop Detector
» Hard Disk Drive
» LAN Card
» Memory and BootROM DIMM's
» EM cover
» Main PCA
» Power Supply Unit
» Ink Supply Station PCA
» Ink Leak Detector
» Cooling Fans
» Electronics Module
» Pinch-Wheels
» Pinch-Wheel Cam
» Vacuum Fan
» Paper-Axis Motor
» Booster Fan
» Media Sensor
» Entry Roller
» Center Guide
» Drive Roller Gear
» Front Platen
» Center Platen
» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door
» disassembly videos
» send feedback or
comments
 

Vacuum Fan
 

WARNING: Switch off the Printer and remove the Power Cord.

 
  1. Remove the Right Rear Cover
       
      2. Remove the Right Hand Cover
       
     

3. Remove the Service Station Assembly
       
    4. Disconnect the Vacuum Fan Cable at position P19 on the Main PCA.
       
    5. Remove the 4 T-20 screws (Type L) that secure the Vacuum Fan to the Sideplate.
       
    6. Remove the Vacuum Fan.
       
 

Installation of Vacuum Fan

WARNING:
When installing the Vacuum Fan make sure that it fits tightly to the Guides in the Sideplate.

 
 
       
© 1994-2006 Hewlett-Packard Company