hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Drive Roller Gear



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Left Hand Cover

			2. Remove the Left Rear Cover

			3. Remove the Ink Supply Station (ISS)

			4. Remove 1 T-25 screw (Type S) from the Drive Roller Gear

			5. Remove the Drive Roller Gear.



	Installation of Gear WARNING: When installing the Drive Roller Gear make sure the screw is fully tightened.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company