hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Electronics Module (as one complete Assembly)



	WARNING: Switch off the Printer and remove the Power Cord.



				1. Remove the Left Rear Cover

				2. Remove the Right Rear Cover

				3. Disconnect ALL Cables from the Main PCA (Right Rear Cover) and ISS PCA (Left Rear Cover) and remove the Ferrites from the left side.

				4. Remove 2 T-15 screws (Type B) from the both sides of the Electronics Module.

				5. Lift the Electronics Module up (to clear it from the shoulder screws) and remove from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company