hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Ink Leak Detector - If Present (Only Applicable to the 5000 Series)



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Left Rear Cover

			2. Remove the Top Cover

			3. Remove the Back Cover

			4. Disconnect the Ink Leak Detector cable at position P2 from the ISS PCA.

			5. Remove one T-15 screw (Type B) to release the cable clip on the Top EMC cover.

			6. Press the retaining clip on the Ink Leak Detector and release it. TIP: A screwdriver can be used to press the retaining clip down.

			7. Remove the Ink Leak Detector from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company