select printer | 5000/5500 series | disassembly | disassembly instructions
hp designjet 5000/5500 series printers
» disassembly instructions
  » disassembly instructions
» Top Cover
» Left Hand Cover
» Right Hand Cover
» Front Panel
» Left Rear Cover
» Right Rear Cover
» Extension Cover
» Media Lever
» Right Hand Trim
» Left Hand Trim
» Back Cover
» Ink Tubes System
» EMC Covers
» Encoder Strip
» Trailing Cable
» Tensioner Assembly
» Carriage and Belt
» Line Sensor
» Scan-Axis Motor
» Cutter Assembly
» Ink Supply Station
» Air Pressurization System
» Service Station
» Drop Detector
» Hard Disk Drive
» LAN Card
» Memory and BootROM DIMM's
» EM cover
» Main PCA
» Power Supply Unit
» Ink Supply Station PCA
» Ink Leak Detector
» Cooling Fans
» Electronics Module
» Pinch-Wheels
» Pinch-Wheel Cam
» Vacuum Fan
» Paper-Axis Motor
» Booster Fan
» Media Sensor
» Entry Roller
» Center Guide
» Drive Roller Gear
» Front Platen
» Center Platen
» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door
» disassembly videos
» send feedback or
comments
 

service station assembly
 

WARNING: Switch off the Printer and remove the Power Cord.

 
  1. Remove the Right Rear Cover
       
      2. Remove the Right Hand Cover
       
   

3. Remove the Printhead Cleaners.
       
   

4. Manually slide the Carriage out of the Service Station.
       
    5. Disconnect the Service Station Cable from the Main PCA (P15).
       
    6. Unclip the Scan-Axis Motor Cable from the Service Station.
       
 

NOTE: Follow the instructions in step 7 carefully; LOOSEN the screw and DO NOT remove.

 

7. Loosen the T-20 screw (Type A) securing the Service Station to the side plate.
       
    8. Remove 2 T-15 screws (Type F) between the two slider rods that attach the Service Station to the Chassis.
       
    9. Standing in front of the Service Station, lift it off the loosened screw.
       
    10. Pull the assembly out towards you and remove from the Printer.
       
 

NOTE: Perform the following Service Calibration if the Service Station Assembly is replaced:

  -Service Station Calibration
© 1994-2006 Hewlett-Packard Company