select printer | 5000/5500 series | disassembly | disassembly instructions
hp designjet 5000/5500 series printers
» disassembly instructions
  » disassembly instructions
» Top Cover
» Left Hand Cover
» Right Hand Cover
» Front Panel
» Left Rear Cover
» Right Rear Cover
» Extension Cover
» Media Lever
» Right Hand Trim
» Left Hand Trim
» Back Cover
» Ink Tubes System
» EMC Covers
» Encoder Strip
» Trailing Cable
» Tensioner Assembly
» Carriage and Belt
» Line Sensor
» Scan-Axis Motor
» Cutter Assembly
» Ink Supply Station
» Air Pressurization System
» Service Station
» Drop Detector
» Hard Disk Drive
» LAN Card
» Memory and BootROM DIMM's
» EM cover
» Main PCA
» Power Supply Unit
» Ink Supply Station PCA
» Ink Leak Detector
» Cooling Fans
» Electronics Module
» Pinch-Wheels
» Pinch-Wheel Cam
» Vacuum Fan
» Paper-Axis Motor
» Booster Fan
» Media Sensor
» Entry Roller
» Center Guide
» Drive Roller Gear
» Front Platen
» Center Platen
» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door
» disassembly videos
» send feedback or
comments
 

Pinch-Wheel cam

 

WARNING: Switch off the Printer and remove the Power Cord.

 
  1. Remove the Right Rear Cover
       
      2. Remove the Left Rear Cover
       
     

3. Remove the Deflectors
       
      4. Remove the Left Hand Cover
       
      5. Remove the Right Hand Cover
       
      6. Remove the Left Hand Trim
       
      7. Remove the Right Hand Trim
       
      8. Remove the Media Lever
       
      9. Remove the Ink Supply Station (ISS)
       
      10. Remove the Service Station Assembly
       
      11. Remove the Vacuum Fan
       
      12. Remove the Electronics Module
       
      13. Remove the Booster Fan
       
      14. Remove the Media Sensor
       
      15. Remove the Entry Roller
       
      16. Remove the Center Guide Assembly
       
      17. Remove the Pinch-Wheels
       
    18. Through the slot in the right Sideplate, remove the T-15 screw (Type H) retaining the cam lever arm.
       
    19. Remove the T-15 Cam screw (Type F).
       
    20. Remove the Cam by sliding it through the slot in the left Sideplate.
       
 

Installation of Cam:
 
1. To install the Cam slide it through the left Sideplate and place it in the cam slot in the beam.
       
    2. Hold the Cam Lever Linkage over its slot in the Sideplate and insert the Cam into it.
       
    3. Push the Cam with the Cam Lever Linkage into the Sideplate.
       
© 1994-2006 Hewlett-Packard Company