hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

media sensor



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Remove the Top Cover

			2. Remove the Right Rear Cover

			3. Remove the Left Rear Cover

			4. Remove the Back Cover

			5. Remove the Electronics Module

			6. Remove the EMC Covers

			7. Remove the Booster Fan

			8. Reach under the Center Guide and carefully remove the Media Sensor mount by pulling it down gently (as shown below).

			TIP: Pull down the Media Sensor by inserting a finger on each side of the sensor and pulling down.



	Installation of Media Sensor WARNING: When installing the Media Sensor, insert the moving part as shown in the diagram.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company