hp designjet 5000/5500 series series printers

select printer | 5000/5500 series | disassembly | disassembly instructions

hp designjet 5000/5500 series printers

» disassembly instructions

» disassembly instructions

» Left Hand Cover

» Right Hand Cover

» Left Rear Cover

» Right Rear Cover

» Extension Cover

» Right Hand Trim

» Left Hand Trim

» Ink Tubes System

» Encoder Strip

» Trailing Cable

» Tensioner Assembly

» Carriage and Belt
» Line Sensor

» Scan-Axis Motor

» Cutter Assembly

» Ink Supply Station

» Air Pressurization System

» Service Station

» Drop Detector

» Hard Disk Drive

» Memory and BootROM DIMM's

» Power Supply Unit

» Ink Supply Station PCA

» Ink Leak Detector

» Cooling Fans

» Electronics Module

» Pinch-Wheels

» Pinch-Wheel Cam

» Paper-Axis Motor

» Media Sensor

» Entry Roller

» Center Guide

» Drive Roller Gear

» Front Platen

» Center Platen

» Deflectors
» PCI-to-IDE PCA
» Heater
» Tube Guide Door

» disassembly videos



	» send feedback or comments

Cutter Assembly



	WARNING: Switch off the Printer and remove the Power Cord.



			1. Open the Top Cover.

			2. Pull the Carriage out along the Printer to the position shown.

			3. Lift up the Carriage Cover and remove ALL the Printheads and close the Carriage Cover.

			4. Slide the Carriage to the position shown.

			5. Push in the 2 retaining clips either side of the Printhead Tube Connector.

			6. Pull the Printhead Tube Connector towards you.

			7. Push the button to release the Printhead Tubes from the Carriage.

			8. Release the retaining clip by pulling it away from the holding brackets.

			9. Remove 1 T-8 screw (Type V) and washer that attaches the Cutter to the Carriage.

			10. Slide the Cutter towards you and remove from the Printer.


privacy statement	using this site means you accept its terms

© 1994-2006 Hewlett-Packard Company